Washing machine drain pump replacement
Washing machine drain pump replacement. When your washing machine fails to empty, the first thing to check is your drain hose.
If it’s blocked with debris, pull it aside and clean out any hair or other bits of fluff that could have ended up there. When you’ve checked the hose, inspect your filter and clear it out if necessary.
Once you know if either of these were the cause for the failure in draining, you can contact a qualified repair expert to help purchase quality replacements for either the drain pump or the filter.
Going through this process won’t be so difficult because you’ll have a professional who will provide quality advice on what brands are best and where you can buy them.
Washing machine drain pump replacement
We will discuss here the steps of replacing the drain pump.
Step 1: Drain The Water
After you’ve turned off your machine and pulled the plug out of the wall, the next step is to drain any water that remains pooled in the device.
Depending on how far along in the washing cycle your appliance was when it spilled over, you may be dealing with excessive water, so have a bowl or container handy nearby to collect as much as possible.
Alternatively, if your appliance includes a hose leading directly into a drain or waste pipe, use it to drain away residual water; otherwise, you can unscrew or remove your filter and drain the water out through there instead.
Step 2: Remove the Back Panels
First, use a screwdriver to remove the top and back panels. Put the appliance on its side because it is heavy to do it yourself.
Don’t forget that the drum is suspended inside the washing machine, so when you lower it make sure not to put too much weight on the lever, or else you might break the mechanism.
Step 3: Remove The Old Pump
Begin by disconnecting the pump wires, hosing, and clamp from the main chamber. The main compartment needs to be drained of water so you can detach the pump house at its base.
Once there’s no more water streaming from the pump, and it has been separated, remove a screwdriver to release the drain hose’s clamp.
Move clamp further down towards the unit end. This will allow for easy separation between pump hoses, thus making it a lot easier for you to attach the replacement pump into its place. Now, all you have to do then is connect the new unit in reverse order!
Step 4: Adjust New Pump
Once you’ve located the new pump, flip it over, face down, and place it into the hole where the previous one was. You get to put it backward now!
Turn your new pump counter-clockwise and firmly push it back into place. Next, use pliers to clamp those pieces together, rewire that part of your machine, clipping it around easily.
You may now unwind knowing that you saved money and accomplished much more than if you had hired someone to do it for you!
FAQs
Is it worthwhile to replace the washing machine’s pump?
A leaking water line or a washer that doesn’t drain may seem minor and something for which one might consider replacing the entire appliance, but instead, it’s better to replace the bad washer.
Doing so can be quite simple – even if you don’t know much about plumbing, you can still swap out the bad part in under an hour.
While this type of project can be a bit intimidating the first time, with some basic tools, like a pair of pliers and a screwdriver, anyone can do it!
How much would it cost to have a drain pump replaced on a washing?
As a general rule of thumb, it’s important to note that it will cost you between $300 and $400 if the washing machine pump needs to be replaced.
Washing machine pump repair is usually necessary when you notice active leaks or if your washing machine tub isn’t draining properly.
Related Guides
