Roper dryer NOT spinning
Roper dryer not spinning. A Roper dryer that starts but doesn’t tumble usually results from a problem with one of several components.
Though some of these problems are more serious, most can be fixed with a little troubleshooting. Use this guide to figure out why your dryer’s drum has stopped turning and how to get it running again.
Roper Dryer Not Spinning
We will discuss here the causes of not spinning the roper dryer.
Damaged Drum Rollers
Dryers rely on drum rollers to rotate the drum. Most have two on the rear, and some have two more supporting the front.
If the rollers are worn out, the dryer won’t turn. To check the condition of the support rollers:
- Remove the belt from the dryer
- Try turning the drum by hand
- If the drum does not rotate freely, check the support rollers for wear
- If one or more of the rollers is worn out, we recommend replacing all of them at the same time as a preventative measure.
Broken Drive Belt
The drive belt is a crucial part of the dryer, as it helps to rotate the drum. Over time, the belt can break from normal use.
If this happens, the dryer won’t be able to function. To see if the belt is broken, try turning the drum by hand. If it spins very easily, the belt will likely be damaged and need to be replaced.
Broken Drum Bearing
The drum bearing is responsible for the dryer drum’s stability. However, over time this part will experience wear and tear.
When this happens, you’ll notice that your dryer doesn’t rotate properly. To check if the drum bearing is the issue, remove the dryer belt and try turning the drum by hand.
If it rotates without issue, the problem likely doesn’t lie with the drum bearing. However, if you hear grinding or squealing noises or it’s difficult to turn, the drum bearing is probably damaged and needs to be replaced.
Damaged Drive Motor
The drive motor is responsible for turning the drum and blower wheel to exhaust the air. To check if the drive motor is at fault, begin by listening for a humming noise.
Even after removing the belt from the engine, the blower wheel may be obstructed if you still hear the humming noise.
Another way to test the drive motor is by attempting to rotate the drum by hand. If the drum doesn’t spin freely, then something is causing it to bind.
However, if the drum turns freely and the blower wheel is clear of obstructions, then it’s likely that the drive motor is defective and will need to be replaced.
FAQs
Is it difficult to change a dryer belt?
A clothes dryer relies on a drive belt to rotate the drum. If this belt snaps, the dryer won’t be able to function.
Replacing the strap is a fairly easy repair that can be done at home, and it’s also very affordable. You’ll only need a few tools and basic knowledge about how to put them to use.
Is there a reset button on my dryer?
If your dryer’s motor doesn’t run, don’t freak out. Many models have a reset button on the control panel. Allow the dryer to cool for about ten minutes, then give the reset button a firm push.
In most cases, this will jumpstart the motor and get your dryer running again. If the reset button doesn’t do the trick, there’s likely an issue with one of the switches or the electrical system.
Conclusion
Most dryer problems are very easy to diagnose and fix! Dryer repair is a simple process that can save you a lot of money. Whether you know how to fix a dryer, checking the lint trap and cleaning the vents regularly is always a good idea. This will keep your dryer running smoothly and prevent fires. If your dryer repair is more serious, contact the experts.
Related Guides
