KitchenAid refrigerator door not closing properly. Your fridge is one of the key appliances in the home.
You can go without other amenities like air conditioning or a hot water heater if you need to, and you can even manage without cooking hot meals.
But food preservation is an absolute must in modern life, which is why it’s so concerning when your fridge door stops closing all the way.
Maybe it has stopped sealing shut or you’ve been having a hard time getting the seal to take hold recently.
No matter what problem your fridge door has been having, we can assist you in finding the cause and achieving a resolution.
Let’s explore the top ten ways to repair your fridge door when it won’t close, seal, or hold a seal.
Kitchenaid Refrigerator Door Not Closing Properly
We will discuss here the causes of not closing the refrigerator door.
Unbalanced the Feet
If your fridge isn’t sealing properly, it might be because the door is hanging unevenly and preventing the gasket from lining up right.
This can often be caused by an uneven floor or an uneven surface that the fridge is sitting on, like a rug. If your floor isn’t level or the fridge is propped up on something uneven, you may need to adjust the feet.
Use a bubble or laser level to make sure that the bottom of the fridge is level. If the floor is level, check that the feet are all the same height and that they’re supporting the fridge evenly.
The gasket, that rubber seal which runs all the way around the fridge and freezer doors, is a common source of fridge door problems.
If the gasket is warped, detached, hardened with age, or otherwise not in good condition, it won’t make the seal necessary to keep the cold air in and the door shut.
An easy fix is to clean the gasket with a damp sponge or washcloth, using some vinegar or mild dish soap if necessary. You can also restore some softness and effectiveness to an older seal with a thin layer of Vaseline.
The chances of your door not aligning and sealing properly are increased if the hinges are damaged. If the door is too heavy or if there are hits to the refrigerator, this can warp or bend the hinges out of shape.
However, if the hinges are only bent, damaged, or rusting through, you don’t need to replace your entire refrigerator. You can simply screw in new inches where the old hinges were installed.
Reschedule the Shelves
Sometimes the problem isn’t as complex as we make it out to be. Something as simple as shelves and drawers that are too close to the fridge door can cause constant blockages and prevent the seal from properly closing.
This problem can be solved by rearranging your fridge shelves and thinking about how much space you need.
By moving where each shelf and drawer slides in, you’ll be able to build a more effective fridge storage design.
Why won’t my refrigerator door close completely?
The door gasket is one potential reason why your fridge door might not be sealing properly.
The door gasket forms a seal around the fridge door to keep cold air in and prevent warm air from entering. If the gasket is old and worn out, it might not provide a tight seal, which can cause the door to open.
How do you get the refrigerator door to close properly?
Before you begin, make sure that you have a pry bar and that the screws on your hinges are loosened. To start, pry off the hinge cap and then use the pry bar to loosen the hinge screws.
Once the screws are loose, begin aligning the door with the top of the refrigerator. If you’re just trying to straighten an upper door, then you should only need to adjust the top hinge.
Conversely, if you’re trying to align a lower door, then you’ll need to adjust the middle hinge.