Dishwasher Door Wont Close

Dishwasher door wont close. Dishwashers are simple to use once you get the hang of them. However, they require a spotlessly clean and dry load to operate correctly.

If your dishwasher’s having trouble starting, check for any obstructions stuck underneath the dishes, such as food scraps or grime that may be blocking the food latch from closing correctly.

Check for loose screws on top of the door before closing it; this could cause the door parts to malfunction and prevent it from latching shut properly.

Ensure that everything is in working condition before trying again, and don’t forget that if you suspect a faulty lid switch, your unit may need professional repair services.

Dishwasher Door Wont Close

dishwasher door wont close 2022 guide

We will discuss here the causes of not closing the dishwasher door.

Installation Issues

A poorly installed dishwasher door may prevent it from closing. The door will sometimes bump into other equipment, causing it to stop closing and controlling the machine from starting.

This problem is usually seen in dishwashers with plastic tubs but not in those with stainless steel tubs. Use a bubble level and check if your machine is level.

If it’s not level, you can rotate the feet and make them shorter by turning them clockwise or lengthen them, clockwise and anticlockwise.

If your machine is old, ensure that the screws holding it against the cabinet are firm; otherwise, let in air that may cushion the feet slightly, allowing the machine to give way whenever water pressure increases.

Dishwasher Racks that Protrude

Fixing a dishwasher is not always necessary. If you notice that your dishwasher won’t close, it may be the case that one of the reasons is because there are dishes in the way.

Another possibility might be if you have something jammed up against some moving parts or on top.

The best thing to do first is to remove the racks and see if anything isn’t sitting properly or the spot is blocked inside – this could very well cause an obstruction or prevent certain components from functioning optimally.

Door Latch Glitch

If your dishwasher’s latch is worn, it may not properly glide into the doorjamb, bouncing back and forth until the machine detects it and quits trying to start. It’s simple to replace the worn-out part.

But if you’re not comfortable doing so, bring in an expert appliance repair technician who can identify and repair the problem swiftly and with minimal hassle or mess.

To begin, establish whether your dishwasher model employs a rolling pin to attach the latch since many do not; instead, they use a push-on spring clip (a simple one!).

Use needle-nose pliers to detach the spring clip from the soap dispenser if yours has that latch mechanism.

After that, press down on the new spring clip bracket while carefully inserting it through the hole of both components (spring clip & soap dispenser) to rejoin both pins with their corresponding screws.

FAQs

What can cause a door not to close properly?

The foremost cause of the door not staying closed is that the locking latch isn’t engaging properly with the strike plate, which is just a crucial part of this mechanism.

Usually, you’ll be able to tell right away because there’d be no audible snaps or clicks when you close the door.

What is the cost of replacing a dishwasher latch?

If your dishwasher doesn’t close or latch properly, that usually means one of the parts inside it is worn out.

The most common replacement part for dishwashers is the door latch which can be found at your local appliance store for $150 to $250.

Conclusion

The dishwasher is a very simple machine. The only thing that causes dishwashers to malfunction is a lack of being cleaned and maintained properly. So if you want your dishwasher to work properly, make sure you clean and maintain it regularly.

If your dishwasher doesn’t seem to be working, check to make sure that it’s clean and that nothing is stuck underneath the dishes. If your dishwasher still isn’t working, it may need to be repaired by a professional, so it’s best to have a technician take a look at it.

Related Guides

Leave a Comment